6 Stage Reverse Osmosis 50GPD System with Diaphragm Booster Pump ¦ Domestic Under Sink RO Water Filter System by Finerfilters
Finerfilters 6 Stage Domestic Under Sink Reverse Osmosis System with Booster Pump
Reverse Osmosis is a technology that is used to remove the large majority (98%+) of contaminants from water. The Reverse Osmosis system works by pushing the water under pressure through a number of increasingly smaller filters and finally through a semi-permeable membrane, essentially trapping all contaminants.
Finerfilters are here to support you before and long after you buy. We provide help through manuals, easy install guides, diagrams, phone & email support.
This system produces up to 190 litres per day of purified water and comes complete with:
A 3 US gallon pressurised storage tank holding 6.5 litres of RO filtered water.
- Installation Manual.
- Chrome Faucet Tap.
- All pipes, pre-filters, post filters, and fittings required for easy installation.
- Booster Pump with high and low-pressure switches.
The membrane can last between 1 and 2 years dependent on water hardness. Filters to be replaced every six months.
Please note:
This system requires a minimum of 29 PSI (2 BAR) to work.
A minimum of 29 PSI (2 bar) is required to operate the booster pump.
Ideal pressure depends upon incoming water temperature but around 60 PSI (4 BAR) is acceptable.
Reverse Osmosis Systems wastewater to make water, and this should be done at high pressure as the water is being forced through microscopic holes which catch contaminants.
This is normal and the same with all RO systems as this is the way the membrane rejects the impure water, which goes to the drain, to produce the pure water.
The system works optimally at 80-90 PSI (5.5 - 6 bar), and to get to the quoted output, we'd recommend running the system on or around this pressure.
This allows the system to reduce the wastewater to pure water ratio and work quicker at producing pure water.
As many people won't have this mains pressure; pumped RO Systems or booster pumps can be purchased from us and added to the system which will increase the pressure output (a minimum of 29 PSI (2 bar) is required to operate the booster pump).
Please ensure that your incoming mains water pressure meets or exceeds this before purchasing.
Finerfilters 6 Stage Domestic Under Sink Reverse Osmosis System with Booster Pump
|
The 6 stages of filtration are; |
|
| Stage 1 |
A 5 micron sediment filter made of 100% pure Polypropylene fibres. Removes Dirt, Sand and Rust. |
| Stage 2 |
A granular activated carbon filter composed of high-performance activated carbon. Removes free Chlorine, Odour, Organic Contaminants, Pesticides and Chemicals. |
| Stage 3 |
A Carbon block filter - composed of high-performance Carbon. Removes Trihalomethanes, Pesticides and Volatile Organic Chemicals (VOCs). |
| Stage 4 |
A high rejection thin film composite 50 GPD Reverse Osmosis membrane with the capacity to produce up to 190L of purified water per day. This membrane removes contaminants present in water including, but not limited to, up to 99% of dissolved Salts, Lead, Copper, Barium, Bacterial By-Products, Oestrogen and Silica. |
| Stage 5 |
A Post-Carbon filter designed to improve taste. It removes any residual impurities and odours from the tank and provides finer conditioning of the purified water. |
| Stage 6 |
Remineralizing filter to enrich the water ions with health essential minerals including Calcium, Magnesium, Potassium and Sodium. |
Plastic Water Storage Tank
Made of food-grade reinforced Polypropylene and contains a food-grade Butyl diaphragm/bladder which holds the water, ensuring tasteless, odourless & contaminant-free water.
There is a small air charge between the outside of the bladder and the inside of the tank. It’s this air pressure that pushes the water out of the tank when the tap is opened.
The tank is pre-charged with air but will require topping up as part of the regular maintenance of your reverse osmosis system. Air can be added using a bicycle pump or similar.
- Can be connected to additional tanks to increase the storage capacity of your Reverse Osmosis system.
- Uses 1/4” Female x 1/4” Pushfit Angled Shut Off Valve.
- Holds 6.5 litres of water.
- Working Pressure: 50 PSI
- Bottom Air Charge Pressure: 5-7 PSI
- Dimensions: 36cm x 25cm x 25cm
System Measurements
6 Stage Reverse Osmosis System with Diaphragm Booster Pump
Length: 45cm
Width: 44cm
Depth: 26cm
Weight: 13.5kg
| Product Name | Finerfilters 6 Stage Domestic Reverse Osmosis Under Sink System with Diaphragm Booster Pump |
|---|---|
| Brand/Manufacturer | Finerfilters |
| Model Number | FF-RO-SYST-D6-PUMP |
| Item Type | Domestic Reverse Osmosis |
| Min. Working Temp. | 0.6°C / 33°F |
| Max. Working Temp. | 40°C / 104°F |
| Expected Lifespan | 6 Months |
| Weight (kg) | 13.500000 |
RO-DOMESTIC-INSTRUCTIONS.pdf 