Samsung WSF100 Genuine Fridge Water Filter

The Samsung WSF100 - Magic Fridge Water Filter Chlorine Taste and Odour The filter produces cleaner, better tasting and healthy drinking water ice. Important: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Samsung WSF100 - Magic Fridge Water Filter operating specifications are as follows: Operating Temperature - min 0.6 deg C - max 38 deg C Operating Pressure - min 138 kPa (20 psi) - max 862 kPa (125 psi) Capacity - 3 028 litres Service Life - 6 months Dimensions - approximately 6 cm x 32 cm Change the filter at least every 6 months. Installation and replacement procedure for the Samsung WSF100 - Magic Fridge Water Filter Turn off the cold water supply. Remove the tubing from the ends of the old filter. Note: Take precautions as water will drain from the filter and pipes. Discard the old water filter. Unscrew the threaded connector and place it over the end of the cut section of pipe coming from the appliance. Push the pipe over the end of the filter that the flow arrow points to. Tighten up the threaded connector. Repeat on the other end of the filter. Turn on the water supply. Check the filter area for leaks. Run water through the dispenser for 3 minutes to purge the system. Reset the Filter Indicator light by pressing and holding then. Ice Type and the Child Lock (or Moisture Control) buttons simultaneously for 3 seconds (the light should turn green). When to change a filter: Important: It is essential that operation, maintenance and filter replacement be carried out per the manufacturer's recommended procedures and guidelines for this product to perform as advertised. Failure to do so may void the warranty.